Description
Overview
A clip-on base profile designed to provide a secure foundation for a compatible capping or finishing profile.
Installation
Supply and install Clip-Top Capping (2 component) CTC30 and CB30 to be applied with all corners/mitres/joins neatly completed as per data sheets by the manufacturer with Polysales recommended contact adhesive to a clean, dry and contaminant free surface, as specified by the drawings for the project. Only CB30 should be applied during installation and the final CTC30 strip applied just prior to handing over the project after all painting etc. has been completed.
Maintenance
1. Post Installation:
- All loose dirt such as dust, grit, sand etc. must be removed, preferably by vacuuming the floor.
- The floor should then be cleaned using neutral detergent, diluted as per the manufacturer’s instructions, scrubbed and dirty cleaning solution wet vacuumed off the floor. (If a wet vacuum is not available, a mop and wringer system can be used).
- Adhesive can be removed with an appropriate detergent/solution such as Polysales Powerclean if necessary. As a principle, aggressive solvents should be avoided as these may affect the finish. More powerful detergents such as Pro-inox from Industroclean can be used to remove persistent soiling which is not removed by the initial clean.
- The stairs should then be rinsed until all traces of the neutral detergent are removed and wet vacuumed to remove all traces of water.
2. Daily
- Sweep/mop using a disposable cloth system such as the Masslinn system or vacuum to remove dust and grit; (Ensure that the vacuum is fitted with a Hepa filtration system in a Healthcare environment)
- Spot or damp mop where required using neutral detergent such as Proclean.
3. Interim or Weekly Clean (Depending on conditions)
- To remove light scuff marks.
- To remove heavy scuff marks:
These products are all available from Industroclean (011) 801 4600.
BoQ Specification
Supply Clip Base CB30.
